Thanks for the suggestions so far everyone. All the electrics work ins the car, lights, radio, power windows etc. Haven't got a way of testing the battery but sure thats the first thing the Greenflag guy tested, and he said battery was fine. Name: James. Ford Model: Fiesta Zetec. Ford Year: 2015. UK/Ireland Location: Yorkshire. Posted April 7, 2015. the heavy steering is due to loss of pump assistance when the engine dies i would agree check the IAC valve. Ive always found it a bit worrying that you lose power steering when the engine isnt running.

It came up with fault code P0122. According to the internet: A P0122 code means that the the car's computer has detected that the TPS (throttle position sensor) is reporting too low a voltage. On some vehicles that lower limit is 0.17 - 0.20 volts (V).

I have just carried out a diesel injector fuel return flow test on my 1.6TDCi and am looking for a little help regarding my results. Below I have posted a picture of the results which took 6 minutes & 41 seconds to achieve. Injector 1: 85 Injector 2: 75 Injector 3: 80 Injector 4:75. I have also uploaded the test to YouTube to show the flow rate:
Suddenly, though, out of nowhere 'ENGINE MALFUNCTION - service NOW' appears on the dash and the engine instantly cuts out, leaving me coasting to a stop. The engine would restart, however would splutter and stop when trying to pull away. After towing home and connecting my OBDII reader, I got a P0087 Fuel Rail pressure too low code.
an oscilloscope and amp clamp could prove a dead spot in the starter, a load tester could prove the vehicle wiring to carry current. the only readily available option is to do volt drop testing on the wiring with a multimeter. Don’t bother with resistance or continuity checking, it doesn’t prove anything. Expand.
Although this is the fifth generation, the car received the MK6 index. In this publication, we will show the purpose of the 5th generation Ford Fiesta fuses and relays with photographs and boxes diagrams in which they are located. Note the cigarette lighter fuse. The purpose of the fuses may differ from the description presented and depend on

2013 Ford Fiesta 1.6L starter replacement. oscar rios. 46 subscribers. Subscribe. Subscribed. 10K views 2 years ago. quick video of how to replace a starter on a Ford Fiesta 1.6L more.

Operation: Removing the starter motor on Ford Focus 1.6 TDCi MK2. Let's see how to remove the starter motor on a Ford Focus 1.6 TDCi second series, following the instructions below. First of all we open the bonnet of our car and we go to disconnect the intake hose from the turbine, loosening the clamp screw; after which we disconnect the The immobilizer, sometimes called the immobiliser, is a type of electronic security device. It helps to prevent the engine from running unless the right key is present. It helps to minimize the risk of theft of the vehicle. If it does not work, that means the vehicle is not recognizing the key as the right one. This can be a frustrating problem. Posted January 31, 2017. I have a 06 plate Ford Focus 1.6 petrol Zetec. I've had it a year and it's been great so far, no problems at all. A month ago whilst driving it all the warning lights on the dash came on for a few seconds, then all went out again. Afterwards the car seemed to have lost power. The fuel filter in your Ford Fiesta is located underneath the vehicle, near the fuel tank. Release the fuel pressure by removing the fuel pump fuse and cranking the engine for a few seconds. Then, locate the filter and remove the old one. Install the new filter and replace the fuel pump fuse. Check your owner's manual for specific instructions
Remove the polyurethane (PU) adhesive cap and heat the adhesive (see Parts Required) for a minimum of 30 minutes. 3. Apply the windshield adhesive in a continuous bead inside the gap between the windshield and the roof panel. Using tape, to secure the surrounding sheet metal and the windshield.
Ford Model: Focus mk3 1.6tdci titanium. Ford Year: 2013. UK/Ireland Location: West Midlands. Posted April 3, 2017. Hi All, just joined up today, although I have viewed this forum before and found it to be useful. focus mk3 won't start, clicks as if it has a flat battery . the display saying "push clutch". This happened after the car has been Jfwd.
  • oo13k9g4c0.pages.dev/200
  • oo13k9g4c0.pages.dev/370
  • oo13k9g4c0.pages.dev/353
  • oo13k9g4c0.pages.dev/395
  • oo13k9g4c0.pages.dev/11
  • oo13k9g4c0.pages.dev/227
  • oo13k9g4c0.pages.dev/360
  • oo13k9g4c0.pages.dev/490

    • ford fiesta 1.6 tdci starter motor location